Overview: The test load is applied via a closed-loop control unit with a load cell, a DC motor and an electronic measurement and control unit. The result is highly accurate measurements at all test loads up to 0.5%. The common load overshoot or undershoot as known from traditional dead weight, or open-loop, systems is eliminated. The absence of mechanical weights not only eliminates friction problems but also makes the equipment less sensitive to misalignments caused by vibrations.
• The whole weight of the tester is 50% less than the traditional dead weights type tester. • Test load selection by keyboard and LCD screen. • Fully automatic test cycles. The hardness Tester features a fully automatic test cycle, load application, holding, unloading, is performed fully automatically. This greatly improves reproducibility of test results since operator influence is eliminated. • Selectable dwell times by screen. The indenter, load, and other test information are shown clearly on the large LCD screen. • The directions for 0.102F/D2 ratios selecting according to the materials and hardness range can be showing on the screen. • Equipped with a 20X optical microscope to measure the diameter of Brinell indention. • Brinell Hardness Calculator (BHC) make the hardness value calculation easier and convenient.
